How to Build a Sturdy Halfpipe

How to Build a Sturdy Halfpipe

Materials Needed In Constructing A Half Pipe

The materials needed are two by four stock, eight sheet of inches wood, ten inches PVC pipe, nails, laminate, one ” screws.

Tools

The tools needed are circular saw, hammer, drill with different bits, fishing line, pen and paper and tape measure.

Steps In Creating A Half Pipe

Look for a location for your project and decide the size of your set-up. Consider the normal sizes of wood when evaluating the size of your half pipe. Start by carefully placing the frames of your project. Remember that there should be two equal sides. Create a four inches wide and eight inches long bracing framework from two-by-four stock.

The set-up’s lower portion should be in 2 parts four-by-eight with the joists of the floor space seven 7/8 inches apart. After that, place the horizontal and vertical braces. The overall height should be three inches. Create a total of 3 pieces. Place a 5″ seven 1/2″ radius curve with the help of a fishing line. This will serve as the bowl of the pipe. Build the braces of the set-up’s side parts.

Use the radius line as the basis for creating additional support. The supports for the lower portion should match up with the vertical support and base support. Connect the cross members with the pair of vertical side supports. They should have a space of 7 1/2 inches from one another. You should reinforce the members where the seams of the wood meet so that the wood will not break when you use it. Install wood decking with the help of three inches screws. Reinforce the decking ramp and the beginning platform.

Place the ramp to the wood for a smoother surface. The beginning platform should be supported by additional joists to accommodate several individuals at once. The grinding rail is the intersection of the starting area and the decking. You have to install an additional element in this area of the pipe to protect the decking and the board.

Place a block in the transition point. Use a ten inches PV pipe and use screws to place in the support frame and wood. A single screw for every eight inches will do trick. This will serve as the cushion for the transition point. Remember that the set-up needs to be easily taken apart since you need to store it away during bad weather. You can also use a cover to the set-up from rain and other elements.